logo comp4

alluminum plate for tpo membrane

Hot Products

h1bg

Our products sell well all over the world, and have advanced technology in the field of aluminum products.

Your demand

Contact Information

Zhengzhou CBD center, China

[email protected]

  • Fasteners and Plates Johns Manville

    Use: Insulation and TPO Membranes. Material: Specially Coated Galvalume. Plate: 3" (7.6 cm) round. Color: Amber. Deck Type: Wood, Steel, Structural Concrete, or Structural Purlins * Galvalume is a registered trademark of BIEC International, Inc. and some

    Contact
  • Plates & Fasteners - Carlisle SynTec

    Carlisle SynTec offers membrane plates for EPDM, TPO, and PVC systems. Extruded aluminum bar designed for securing and sealing compression type flashing terminations. These pre-assembled fasteners and plates help applicators save time and labor.

    Contact
  • TPO Coated Aluminum Metal Johns Manville

    Summary. Use: Fabricated by the contractor into metal flashings and edge details. It is used to provide monolithic water-tight protection for both adhered and mechanically fastened roofing assemblies. Materials: 30 mil (0.76 mm) UV-resistant TPO (thermoplastic polyolefin) membrane laminated to .040 aluminum. Color: White.

    Contact
  • UltraPly™ TPO Coated Metal

    1. Install UltraPly TPO Coated Metal with ⅛" to ¼" (3 to 6 mm) between adjoining sections. 2. Install 2" (50 mm) wide heat resistant tape over joints in UltraPly TPO Coated Metal. 3. Heat weld a 6" (150 mm) wide piece of UltraPly TPO Unsupported Flashing over the joint. 4. Robotic welds to UltraPly TPO Coated Metal must be at least 1½" (40 mm) wide.

    Contact
  • Tremco TPO Installation Manual

    2. All stress plates must set completely on the membrane allowing a minimum of ½” in from the edge of the underlying membrane. Rolls are marked with an “X” for easy location of fastener placement. 3. Also allow a minimum of two inches from the edge of the stress plate to the edge of the

    Contact
  • Roofing Products - Mule-Hide

    2.4" Seam Plate. A round Galvalume-coated metal plate with (14) barbed anchors and reinforcing ribs for superior wind uplift resistance. Designed for the mechanical attachment of the Mule-Hide Reinforced EPDM, PVC and TPO membranes. The 2.4" Seam Plates can also be used with Mule-Hide HDP Fasteners, EHD Fasteners, reinforced 6" wide RMS or 6" wide and 10" wide RUSS™ Strip.

    Contact
  • TPO Membrane - Carlisle SynTec

    TPO (thermoplastic polyolefin) membrane is the largest segment in the commercial roofing industry, and no manufacturer has more TPO experience than Carlisle. Carlisle’s Sure-Weld TPO membranes have the industry-leading OctaGuard XT weathering package for enhanced long-term weathering.

    Contact
  • GAF TPO Membranes

    GAF TPO Roofing Membranes Include: Smooth TPO, Fleece-Back TPO, Self-Adhered TPO, TPO Colors, & Extreme TPO.

    Contact
  • Aluminum Sheets & Plates - Amazon

    6061 Extra Thick Aluminum Sheet - 12 Inch x 12 Inch x ¼ Inch - Flat Plain Plate Panel Aluminium Metal Sheets Finely Polished and Deburred. 4.8 out of 5 stars 63. $29.99 $ 29. 99. $2.00 coupon applied at checkout Save $2.00 with coupon. Get it as soon as Tue, Apr 13. FREE Shipping by Amazon.

    Contact
  • 6 Elements of a Perfect TPO Roofing System

    Membrane. First, a little bit about the membrane. TPO stands for Thermoplastic PolyolefinContact
  • UltraPly™ TPO Membrane

    Curbs, walls, and expansion joints must be anchored with appropriate base tie-in detail, either using seam plates and fasteners or using UltraPly QuickSeam Reinforced Perimeter Fastening (RPF) Strip and Batten Strip or 2" Metal Seam Plates. Curbs and walls must be flashed using minimum 0.045" UltraPly TPO Membrane or UltraPly TPO

    Contact
  • GAF EverGuard® & Everguard Extreme® TPO Coated Metal

    24-gauge steel with a 25-mil thick membrane film that cuts and forms like standard sheet metal. Benefits Field and flashing TPO membrane heat welds directly to coated metal

    Contact
  • Roofing Screw, Roofing Plates, Termination Bar

    Roof Stress Plate Design: Smaller plates, 2 to 2-1/2 inches are for membrane and seams. Larger plates, 2-3/4 to 3" are for insulation board. Plates are design to fit the roofing screw wire size (12, 14,

    Contact
  • Standard for TPO Membrane Systems - RCABC Roofing

    While sheet membrane Conventionally Insulated Roof Systems are prolific and perhaps the most common type of waterproofing roof system, the Code offers little guidance for other roof types, including uninsulated roof systems, liquid membrane systems and systems insulated above the membrane

    Contact
  • Specialty Roofing Products Johns Manville

    The one-piece spun aluminum body has a TPO-coated flange for direct hot air welding of TPO roof membranes. The drain flange has a depressed sump area for improved flow and to facilitate drainage. One-piece Seamless Body: 0.125" (3 mm) spun aluminum with 12" (30.48 cm) drain stem length, and an extra large 17.5" (44.45 cm) diameter TPO

    Contact
  • GAF TPO Roofing Systems

    Short for thermoplastic polyolefin, TPO is a single-ply roofing membrane that offers excellent performance at a cost-effective price. Heat-welded seams provide superior strength. TPO's long-term heat, UV, and natural fungal resistance, plus flexibility without need for plasticizers also make TPO

    Contact
  • TPO Roofing Systems Firestone Building Products

    Thermoplastic polyolefin (TPO) single-ply roofing membranes are among the fastest growing commercial roofing products and have gained praise across the industry for their many performance and installation advantages. As demand increases for heat-reflective and energy efficient roofing systems, you can rely on TPO single-ply roofing membranes

    Contact
  • Termination Bars OMG Roofing Products

    The OMG Termination Bar is designed to terminate single-ply membrane at parapet walls and penetrations. Termination Bar is made of extruded aluminum (6063 T6 alloy) with a mill finish, or

    Contact
  • 100 mil x 12' x 100' VersiFleece TPO Membrane

    Versico's VersiFleece membranes are manufactured using a hot-melt extrusion process for complete scrim encapsulation. Once the VersiWeld TPO is reinforced and enhanced with fleece, the total sheet thicknesses available are creating a very tough, durable and versatile sheet

    Contact
  • Roof Waterproofing Membrane BUR Mod-Bit EPDM TPO

    Superior RV® Liquid Rubber Roofing is a liquid applied roof membrane system that provides permanent restoration for TPO rubber, EPDM rubber, aluminum, fiberglass, steel, and many other trailer &

    Contact
  • Roofing Products - Mule-Hide

    TPO Coated Metal. A 24-gauge galvanized steel sheet coated with a layer of 0.035" non-reinforced TPO flashing. TPO Coated Metal is cut into the appropriate width and used to fabricate metal drip edges or

    Contact
  • Windy Conditions - Best Materials

    5. Continue this process for each adjoining sheet. Membrane Creeping or Moving What to do when the membrane is creeping or moving causing wrinkles throughout the membrane surface: 1. The operator of the robot must apply foot pressure to the membrane, kicking and sliding the membrane under the robot to keep the membrane tight. TPO

    Contact

NEED ANY HELP?

If you are interested in our products, or have any questions for us, you can click the button below

Contact Us

Copyright © 2020.Henan Haomei Aluminum. All rights reserved.Sitemap